Tables
Table 2-1 Tools and instruments required for the commissioning.......................................................................2-2
Table 5-1 Parameters available in the Software Download dialog box................................................................5-5
Table 5-2 Parameters in the Software Activation dialog box...............................................................................5-7
Table 6-1 Mapping between the board/module names shown in the window and the actual names...................6-6
Table 8-1 Normal status of the LEDs on the board and modules in the BBU.....................................................8-2
Table 8-2 Normal status of the LEDs on the DRFU............................................................................................8-2
Table 8-3 Normal status of the LEDs on the GRFU............................................................................................8-3
Table 8-4 Normal status of the LEDs on the GATM...........................................................................................8-3
Table 8-5 Normal status of the LEDs on the FMUA...........................................................................................8-3
Table 8-6 Normal status of the LEDs on the DPMU...........................................................................................8-4
Table 8-7 Parameters in the loopback test dialog box..........................................................................................8-7
Table 10-1 Parameters in the Environment Monitor dialog box........................................................................10-3
Table 11-1 Possible causes and handling suggestions for failed communication between the Site Maintenance
Terminal and the BTS.........................................................................................................................................11-2
Table 11-2 Meaning of the states of the LIU LED (UELP used)......................................................................11-4
Table 11-3 Meanings of the states of the LIU LED (UELP not used)...............................................................11-5
Table 11-4 Possible causes and handling suggestions for service dialing failure..............................................11-6
Table 11-5 Description of the DIP switch SW2 on the GTMU.........................................................................11-6
Table 12-1 BTS commissioning data sheet........................................................................................................12-1
BTS3900A GSM
Commissioning Guide Tables
Issue 04 (2008-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
v
To Next Page
Loading...
Need help?
General
