A: Log in to the CLI, and run the enable and configure
terminal commands in sequence to enter the global
configuration mode. Then run the display elabel
command.
11.
Q: How do I view the software version of the IAD?
A: Log in to the CLI, and run the enable and configure
terminal commands in sequence to enter the global
configuration mode. Then run the display version
command.
12.
Q: How do I change the protocol?
− A: To change to the SIP mode, log in to the CLI, run
the enable and configure terminal commands in
sequence to enter the global configuration mode, and
run the protocol-mode sip command.
− To change to the MGCP mode, log in to the CLI, run
the enable and configure terminal commands in
sequence to enter the global configuration mode, and
run the protocol-mode mgcp command.
13.
Q: How do I view the system information?
A: For details, see Maintenance > Viewing the System
Information in the eSpace IAD Product Documentation.
14.
Q: How do I set the VLAN priority on the IAD?
A: For details, see Configuring the VLAN in the eSpace
IAD Product Documentation.
15.
Q: How do I set the fax function on the IAD?
A: For details, see Configuration in the eSpace IAD
Product Documentation.
16.
Q: How do I enable the pulse dialing function?
A: Log in to the CLI, and run the enable, configure
terminal, and advanced commands to enter the advanced
mode. Then run the pstnport attribute set 0 enable
command. If port 0 needs to be connected to the DTMF
phone, run the pstnport attribute set 0 disable command
to disable the pulse dialing function.
To Next Page
Loading...
