4
3b
3a
3 Installing a Board
Installing a Board
Loosen the screws on the ller panel
and use the at-head screwdriver to
remove the ller panel.
Adjusting Components on the Board
If you want to use the T1 trunk, you must remove the jumper caps on the CVP
board (U1910&U1930) or MTU board (U1911&U1960&U1981).
Insert the board into the empty slot,
press the ejector lever into place,
and fasten the captive screws.
SD0 SD1
If you want to use the built-in VMS service (U1911&U1960&U1981) or
customize the system announcements, ensure that you have installed an SD
card in slot 0 of the MTU board.
To Next Page
Loading...
