7
3General Functions
Booting the FWT
The boot process of the FWT will last about 20 sec-
onds. Then you can view the signal strength.
Note
If the signal strength indicators remain off, the
FWT may be faulty or not in coverage area.
Please consult the local agent.
Making or Answering Calls
1 Before off-hook, make sure at least one signal
strength LED is on.
2 Dial the number in either of the following ways:
• Dial a telephone number in a regular way, and the
number will be dialed out in several seconds.
• Dial all the digits of the number plus one #. The
FWT will immediately dial the number.
3 Make sure to hook on the telephone in place, so
that you can receive calls.
Adjusting the Voice Volume
You can adjust the voice volume either when the tele-
phone is in standby mode or working mode. Four vol-
ume levels are available, with level 1 being the lowest
and level 4 the highest.
Adjusting the Volume in Standby
Mode
1 Hook off and you can hear the dial tone, which
means the telephone service is available.
2 Press #*1 to adjust the volume.
3 Press keys from 1 to 4 to select the desired vol-
umn. The keys from 1 to 4 represents volumn
level from 1 to 4.
4 After selecting the desired volume, press * key
to save it. If you hear the confirmation tone of a
"toot", you have successfully set the volume
level.
To Next Page
Loading...
