Quantity Power Distribution Device Name Remarks
Pyromagnetic MCCB; this part is
used for setting parameters in
the assembly factory. It is not
included in the document.
■Involved □Not involved
Device Name Project Configuration
11D ATS
■Involved □Not involved
8D ATS ■Involved □Not involved
3D ATS
■Involved □Not involved
SMU05A ■Involved □Not involved
UPS5000-A
■Involved □Not involved
UPS2000-G ■Involved □Not involved
UPS5000-E
■Involved □Not involved
UPS5000-S ■Involved □Not involved
Integrated UPS
BCB ■Involved □Not involved
MCCB
Table 1 Initial Configuration Parameters for Power Supply and Distribution Devices
Note: The following device parameters are not all parameters of the devices. Only the parameters that need to be set for the project are listed. Default values will be used for the other parameters
so they do not need to be set. To view other device parameters, see the user manual for the corresponding device.
If voltage/frequency settings for power distribution devices are involved, adjust the voltage and frequency settings based on the local voltage system and check whether the voltage thresholds and
frequency hysteresis meet setting requirements before first operation.
ETP4830 ■Involved □Not involved
■Involved □Not involved
Inverter ■Involved □Not involved
AC PDF
■Involved □Not involved
To Next Page
Loading...
