To Next Page
F
fgardnerAug 2, 2025
What to do after an alarm is cleared on Huawei FusionModule2000 Storage?
- BBryan MooreAug 2, 2025
After an alarm is cleared on Huawei Storage, prepare a report to record the alarm handling process.
What to do after an alarm is cleared on Huawei FusionModule2000 Storage?
After an alarm is cleared on Huawei Storage, prepare a report to record the alarm handling process.
What to do if an alarm is generated in Huawei FusionModule2000 Storage?
If an alarm is generated in Huawei Storage, the first step is to log in to the ECC800-Pro WebUI. From there, navigate to Home > Active Alarms to view the current alarm information and then collect alarm information.
General| Form Factor | Modular |
|---|---|
| Category | Enterprise Storage |
| Power Density | High |
| Interface | Ethernet, Fibre Channel |
| Power Supply | Redundant power supplies |
| Deployment | Data Center |
Details the document's objective of describing site requirements and installation methods.
Identifies the target readers for this installation guide.
Outlines broad safety guidelines for installation, operation, and maintenance.
Details specific safety measures related to electrical hazards during installation.
Covers crucial safety protocols for handling and installing batteries to prevent hazards.
Specifies safety measures and best practices for moving and positioning equipment.
Guides the process of unpacking, inspecting, and accepting delivered equipment.
Details physical site specifications and layout considerations for installation.
Enumerates the specific tools and instruments needed for the installation process.
Specifies how to arrange modules in a dual-row aisle containment setup.
Details the arrangement of modules in a single-row aisle containment setup.
Addresses layout considerations for dual-row aisles when a column is present.
Provides essential safety and preparatory guidelines before installing bases.
Guides the installation of bases that have adjustable height and depth.
Explains how to properly ground the installed bases for safety.
Instructions for safely transporting and positioning the Power Distribution Cabinet.
Describes how to install an optional top frame to increase cabinet height.
Provides guidance on safely moving various types of cabinets.
Instructions for installing horizontal ground bars within cabinets.
Specific instructions for installing the 25 kW NetCol5000-A air conditioner model.
Instructions for installing an adaptive frame for 300 mm wide air conditioners.
Instructions for installing the 42 kW NetCol5000-A air conditioner model.
Procedure for ensuring cabinets are level for proper alignment and stability.
Describes the M-type grounding solution for cabinets.
Guides the installation of sealing plates in single-row aisle configurations.
Covers the installation of various types of skylights for aisle containment.
Covers the process of installing end doors for aisle containment.
Guides the installation of cable troughs, including specific sizes and scenarios.
Details the installation of cable trays, including different configurations.
Safety precautions and procedures for installing batteries.
Details the installation of a Power Distribution Box for air conditioners.
Shows typical positions for monitoring devices within a network cabinet.
Covers the installation of the ECC800 monitoring controller.
Describes mounting monitoring devices onto control skylights.
Instructions for installing monitoring cameras, including SD card setup.
Details the placement of monitoring components on end doors.
Step-by-step guide for installing smart ETH gateways.
Outlines concealed vs. open installation methods for access control systems.
Covers the installation of magnetic locks for double doors.
Guides the installation of magnetic locks for single doors.
Outlines general rules for attaching cable labels and organizing cables.
Describes the overall process for connecting cables, including measurement and routing.
Details the procedures and precautions for connecting battery cables.
Step-by-step guide for installing expansion bolts.
Details the preparation of monitoring cables, including cord end terminals.
