FusionModule2000 Smart Modular Data Center
Installation Guide
15 Installing Monitoring Devices
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Procedure
Step 1 Remove the baffle plate from the installation position, as shown by (1) in Figure 15-51.
Figure 15-51 Installing a card reader with a keypad
Step 2 Secure the baffle plate with a cable hole on the lower part to the pad mounting kit, as shown
by (2) in Figure 15-51.
Keep the protruding plane of the baffle plate flush with the end plane of the pad mounting kit.
Step 3 Remove the M2x5 screws (set aside) of the card reader with a keypad and take off the
baseplate, as shown by (3) and (4) in Figure 15-51.
Step 4 Secure the baseplate to the baffle plate using two M3x8 countersunk screws, as shown by (5)
in Figure 15-51.
Step 5 Route the cable of the card reader with a keypad through the cable hole in the baffle plate, as
shown by (6) in Figure 15-51.
Step 6 Secure the card reader with a keypad to the baseplate, as shown by (7) and (8) in Figure
15-51.
----End
15.4.9.4 (Optional) Installing an IC Card Reader
Context
The BOM number of an IC card reader is 06080327.
To Next Page
Loading...
