Huawei FusionModule2000 - Installing a Monitoring Device on the Pad Mounting Kit

FusionModule2000 Smart Modular Data Center
Installation Guide
15 Installing Monitoring Devices
Issue 02 (2018-03-31)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
211
Figure 15-47 Installing a button
Step 2 Remove the buckle from the button mounting position, as shown by (2) in Figure 15-47.
Step 3 Secure the button to the post using the nut delivered with the button, as shown by (3) in
Figure 15-47.
Step 4 Route the button cable out of the cable hole in the upper part of the post and then into the
upper frame mounting kit of the end door.
Step 5 Reinstall the post side plate, as shown by (4) in Figure 15-47.
----End
15.4.9 Installing a Monitoring Device on the Pad Mounting Kit

The BOM number of the pad mounting kit is 21242016.

In dual-row aisle containment scenarios, install the pad mounting kit on the end door
hanger marked with R at the PDC.

In single-row aisle containment scenarios, install the pad mounting kit on the end door
hanger at the PDC.