4
3. On the I want to... Connect to the Internet page, choose Connect
automatically, and click Next.
The HG255e supports Ethernet compliance uplink mode, meaning you can
use the HG255e with a network interface on the wall for Internet access.
After you complete the preceding settings, check the status of the Internet indicator
light. When the Internet indicator light turns steady green, you can start browsing the
Internet.
You need to perform the preceding operations on a computer once only. The next
time you power on your computer, you can browse the Internet without performing
the same configurations.
Configuring a Wireless Account
After you complete the preceding settings, click Try WLAN, you will see the I want
to Set Up WLAN page used to configure the wireless account.
The default SSID and WLAN Key printed on the HG255e's rear panel are
unique and secure. If you do not want to change them, just turn the WLAN
switch on.
For security reasons or to make the password easy to remember, you can change
the wireless network name and password as follows:
1. On the I want to Set Up WLAN page, choose the 2.4 GHz WLAN network.
2. Enter your desired SSID (WLAN name) and WLAN password.
3. Click Save.
6 Wireless Connection Setup
The wireless configuration software provided by Windows is used as an example to
describe how to set up a wireless connection.
On Windows 7
1. Choose Start > Control Panel > Network and Internet > Network and
Sharing Center > Change adapter settings. Right-click Wireless Network
Connection, and select Connect/Disconnect.
2. From the wireless network list, select the WLAN provided by the HG255e.
Click Connect.
3. In the displayed dialog box, enter the WLAN password and click OK.
To Next Page
Loading...
Need help?
General
