5
Step 1 Use an optical fiber to connect the OPTICAL port on the GPON terminal to the
optical port in the wall.
Step 2 Use a coaxial cable to connect the CATV port to a TV set or set top box (STB).
Step 3 Use a network cable to connect the LAN port to a PC or the Ethernet port on
the IP STB.
Step 4 Use a phone line to connect the TEL port to a phone or fax machine.
Step 5 Use a power adapter to connect the POWER port to the power socket.
Step 6 Use a USB data cable to connect the USB port to the USB storage device.
Step 7 Press the ON/OFF power switch.
Step 8 Press the WLAN switch to enable the Wi-Fi access function. By default, this
function is enabled.
Step 9 Press the WPS switch to enable the WPS encryption function.
1.The optical connector connected to the OPTICAL port is an SC/APC connector, and the
type of the optical connector connected to the optical port in the wall is determined by practical
conditions.
2.To ensure normal use of fibers, make sure that the fiber bend radius is larger than 30 mm.
The preceding figure connects the power adapter as an example. When connecting the
backup battery unit , please see the usage guide to the backup battery for details .
Before enabling the WPS encryption function of a GPON terminal, ensure that the function is
set in the system software in advance. After successful setting, press the WPS switch for the
settings to take effect.
To Next Page
Loading...
