7 Installing a Day & Night High Speed Dome IPC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Step 5 Align the dome IPC with the bracket. Mount the IPC on the bracket and rotate the IPC
clockwise so that the holes on the bracket are aligned with the screw holes on the installation
base of the IPC. Then, lock three screws between the bracket and the IPC, as shown in Figure
7-7.
Figure 7-7 Fixing the IPC onto the bracket
Step 6 Install the assembled high-speed dome IPC on the wall and fasten the four screws.
----End
7.3.2 Installing the IPC on the Ceiling
Step 1 Keep the transparent dome of the IPC upward. Rotate the dome anticlockwise to open the
dome. Take out the foam and remove the protective film on the transparent dome. Then,
rotate the dome clockwise to install the dome.
Step 2 Determine the positions of installation holes on the ceiling based on the installation
dimensions of the bracket and mark the holes. Use a percussion drill bit with a diameter of 8
mm to drill four holes that are 60 mm deep. Figure 7-8 shows the installation dimensions (in
the unit of mm) of the bracket.
To Next Page
Loading...