8 Installing an Infrared High Speed Dome IPC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Step 5 Install the assembled high-speed dome IPC on the wall and fasten the four screws.
----End
8.3.2 Installing the IPC on the Ceiling
Step 1 Determine the positions of installation holes on the ceiling based on the installation
dimensions of the bracket and mark the holes. Use a percussion drill bit with a diameter of 8
mm to drill four holes that are 60 mm deep. Figure 8-7 shows the installation dimensions (in
the unit of mm) of the bracket.
Figure 8-7 Determining the positions of installation holes
Step 2 Drive four expansion bolts into the holes.
Step 3 Route the multi-connector cable through the ceiling-mounted bracket, as shown in Figure 8-8.
To Next Page
Loading...