19
(Optional) Connecting Socket Cables
5.3
•
Cables 1755, 1758, 2066, 2065, 1761, and
1766 are pre-installed. Cables 1756, 1751,
1759, 1752, 1757, 1763, 1760, 1765, 1762,
and 1764 need to be installed.
•
The cables to be installed can be obtained
from the cable binding position shown in
the figure.
1. Select a 110 V or 220 V socket as required.
2. Connect the live and neutral wires.
Scenario 1: Installing a 110 V Socket
1. Connect the live wire
and neutral wire from
the mains to positions
1 and 2 of the XT9
terminal block.
This procedure applies only to the models listed in the table below.
To Next Page
Loading...
