39
8
Commissioning (SmartLogger WebUI)
•
Only the Windows 7 operating system and later are supported.
•
Browser: Chrome 52, Firefox 58, or Internet Explorer 9, or a later version is recommended.
•
The WebUI screenshots are for reference only.
1. Connect the network port on your PC to the WAN or LAN port on the SmartLogger
through a network cable.
2. Set the IP address of the PC. Ensure that the IP address is in the same subnet as that of
the SmartLogger.
Preparations and WebUI Login
8.1
•
When the IP address of the WAN port is in the network segment from 192.168.8.1 to
192.168.8.255, set the default gateway to 192.168.8.1 and the IP address of the LAN port
to 192.168.3.10. If the connected port is a LAN port, you need to adjust the network
configuration of the PC.
•
It is recommended that the PC be connected to the WAN port of the SmartLogger or the
GE port of the SmartModule. When the PC is connected to the GE port of the
SmartModule, adjust the network configuration of the PC in the same way as when the PC
is connected to the LAN port of the SmartLogger.
3. Set LAN parameters.
•
If the SmartLogger is connected to a
LAN and a proxy server has been
configured, you need to cancel the
proxy server configurations.
•
If the SmartLogger is connected to
the Internet and the PC is connected
to the LAN, do not cancel the proxy
server configurations.
a. Open Internet Explorer.
b. Choose Tools > Internet Options.
c. Click the Connections tab and
click LAN Settings.
d. Clear Use a proxy server for your
LAN (These settings will not
apply to other connections).
e. Click OK.
To Next Page
Loading...
