Huawei LUNA2000-2.0MWH Series - Page 41

40
• Protect the password by changing it periodically, and keep it secure. If you lose the
password, the device must be restored to its factory settings. The Company will not be
held liable for any losses resulting from improper password management.
• You will be locked out for 10 minutes after five failed password attempts in 5 minutes.
• A dialog box with recent login information is displayed after login. Click OK.
• Update the SmartLogger software as required. Contact the Company's engineers to obtain
the update package and guide and complete the update accordingly.
Commissioning Using Deployment Wizard
8.2
1. Enter https:// XX.XX.XX.XX (IP address of the SmartLogger) in the address bar of your
browser. If you log in to the WebUI for the first time, a security risk warning is displayed.
Click Continue to this website.
2. Select a desired language.
3. Select the User Name and enter the Password according to the following table, and then
click Log In.
The screenshots in this document correspond to FusionSolar V800R021C10SPC010 and are
for reference only.
If…
Then
…
On the login page, the
User Name
is admin
by
default.
1.
Enter the initial password Changeme in the Password and click
Log In.
2.
Change the initial password as prompted and use the admin
user
name and new password to log in again.
On the login page, the
User Name is empty by
default.
Select
installer in the User Name, set the login password as
prompted, and click
Log In.
4. Click Deployment Wizard and set parameters as prompted. Click Skip for unused devices.
•
Complete settings on the Basic parameters page.
•
After devices are connected, click Search for Device to check cable connections,
identify the topology, and rectify alarms.
•
(Optional) After searching for devices, set the Microgrid compatibility, Grid
connection state, and Grid Code based on the site requirements.
• This procedure applies only to SmartLogger V300R023C00 and later versions.
• In microgrid or off-grid scenarios, you are advised to set Microgrid compatibility to
Enable.
• In grid-tied scenarios, set Grid connection state to On-grid (PQ). In off-grid scenarios,
set Grid connection state to Off-grid (VSG).