41
•
Connect to the power meter.
•
Connect to the EMI.
•
Set the battery control parameters. Set the working mode to Charge/Discharge based
on grid dispatch.
•
During the process of Search for Device, do not perform upgrade operations (such as
upgrading through the app, network management system, or WebUI).
•
When you click Search for Device, cable connections (DC and AC) will be checked before
device search (not applicable to third-party devices), and a device address will be
automatically allocated.
•
After the cable connection check and device search are complete, if a cable connection
alarm is generated, you can click the alarm icon to view the corresponding alarm
information.
•
After the cable connection check and device search are complete, click the icon to
view the corresponding topology information.
If this parameter is set to Disable, automatic SOC calibration is not
allowed for battery racks.
for battery racks. During calibration, the cut-off SOC settings will be
ineffective and the response of the charge and discharge power may be
impacted temporarily.
If this parameter is set to Disable, automatic SOH calibration is not
allowed for battery racks.
If this parameter is set to Enable, the ESS automatically calibrates the
SOH precision and fully charges and discharges each battery rack in turn.
To Next Page
Loading...
