1. If the Master FTTR is not powered on or the power switch of the Master FTTR is turned
o, all indicators are in the O state.
2. What can I do if the indicator status is abnormal?
a. Check whether the corresponding optical, network, POTS, or USB port is properly
connected.
One end of the
ber connector is located at the rear of a Master FTTR, and the other
end is located on the wall or in the weak-current box.
Note: Do not look into an optical port with naked eyes.
b. If the WLAN indicator is abnormal, press the WLAN/WPS button on the Master FTTR
to enable the WLAN function.
c. Restart the Master FTTR.
Press the On/O button to turn o the Master FTTR. After a few seconds, turn on the
Master FTTR.
d. If the fault persists, contact the operator's service hotline and turn to the installation
and maintenance personnel for help.
Huawei OptiXstar V183
Quick Start 4 Indicator Description
Issue 01 (2023-04-28) Copyright © Huawei Technologies Co., Ltd. 9
To Next Page
Loading...
