3
3 Installing the MA5675
Installation Procedure
MA5675 can be placed on a horizontal workbench or mounted onto a wall horizontally.
The methods for mounting the MA5675 onto a wall are the same. The procedure is as
follows:
Step 1
Mark the positions of two holes (with a spacing listed in the following table) used for
mounting a MA5675.
Step 2
Select a proper drill according to the outer diameter of the screws. Use a hammer drill to
drill the marked positions on the wall. Then clean the wall and install two expansion
bolts.
Step 3
Use a screwdriver to fasten the screws into the expansion bolts, leaving the heads of the
screws 3 mm over the wall. Then install the MA5675 to the screws.
Horizontal Installation
1. Do not install MA5675 outdoors or on the outdoor cabinets.
2. MA5675 can be mounted onto a wall or be placed on a workbench. Do not install MA5675 in
other modes, such as the ceiling.
To Next Page
Loading...
