Huawei SUN2000-115KTL-M2 User Manual

8.6 Resetting and Turning On the DC Switch
Prerequisites
If internal inverter fault is displayed on the mobile app or remote monitoring
system and the DC switch is OFF, the DC switch of the inverter has been
automatically turned
o. In this case, rectify the fault based on the alarm
handling suggestions before turning on the DC switch.
Procedure
Step 1 Loosen the caps of the RESET buttons for the three DC switches, and press the
RESET buttons inwards until you cannot go any further.
Step 2 Set the DC switches to ON.
Step 3 Tighten the caps of the RESET buttons.
Figure 8-17 Resetting and turning on the DC switch (DC SWITCH 1 is used as an
example)
----End
SUN2000-(100KTL, 110KTL, 115KTL)-M2
User Manual 8 Maintenance
Issue 07 (2023-04-30) Copyright © Huawei Technologies Co., Ltd. 123

Huawei SUN2000-115KTL-M2 Specifications

General

Rated Output Power	115 kW
Input Voltage Range	200 V - 1000 V
Max. DC Voltage	1100 V
Maximum DC Input Voltage	1100 V
Start Voltage	200 V
Rated AC Power	115 kW
Maximum AC Output Power	115 kW
Rated AC Voltage	400 V
Rated AC Frequency	50 Hz / 60 Hz
AC Output Frequency	50 Hz / 60 Hz
Max. Efficiency	98.6%
MPPT Efficiency	99.9%
Operating Temperature Range	-25 °C to +60 °C
Protection Degree	IP65
MPPT Voltage Range	200 V - 1000 V
Max. Apparent AC Power	126500 VA
Power Factor Adjustment Range	0.8 leading - 0.8 lagging
Max. DC Power	172500 W
Maximum DC Input Power	172500 W
Max. Output Current	182 A
Cooling	Forced air cooling
Cooling Method	Forced air cooling