5
Positive connector
Negative
connector
Positive metal terminals
Negative metal terminals
Common PV cables with a cross-
sectional area of 4 mm² in the
industry are recommended.
Ensure that cables cannot
be removed after crimped.
Positive and negative metal terminals:
Negative metal terminal (male)
Positive metal terminal (female)
The skid automatically
starts after the ejector
lever is fastened.
1. Pull back the DC input power cables to check whether the cables would be disconnected.
2. If DC input power cables are reversely connected and the DC switch is ON, do not turn off
the DC switch immediately. Otherwise, the equipment may be damaged. You can
disconnect the DC input power cable on the PV string side or wait until the PV string
voltage reduces to a value within the safety range. Then, turn off the DC switch, remove
the positive and negative connectors, and rectify the connection.
Recommended: H4TC0001
(Amphenol)
Recommended: H4TW0001
(Amphenol)
Click
To Next Page
Loading...
