Huawei USG6000E Series - 2.9 USG6635 E, USG6640 E-K, USG6655 E

Figure 2-17 Appearance and auxiliary materials of the USG6635E, USG6640E-K,
USG6655E
NO TE
● By default, 40GE optical interface 40GE0/0/1 is unavailable. To use it, run the set device
port-cong-mode 40g-port enable command to enable it. However, after that, 10GE
optical interfaces numbered XGE0/0/8 to XGE0/0/11 become unavailable.
● The power cable varies according to the delivery country.
Cable Connection
Connect cables according to Figure 2-18 and power on the device. As device does
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for
conguration.
HUAWEI USG6000E Series Quick Start 2 Device Introduction and Cable Connection
Issue 02 (2022-08-22) Copyright © Huawei Technologies Co., Ltd. 21