Huawei USG6000E Series - 2.10 USG6680 E

2.10 USG6680E
Device and Auxiliary Materials
Figure 2-19 Appearance and auxiliary materials of the USG6680E
NO TE
● By default, 40GE optical interfaces 40GE0/0/2 and 40GE0/0/3 are unavailable. To use
them, run the set device port-cong-mode 40g-port enable
command to enable them. However, after that, 10GE optical interfaces numbered
XGE0/0/20 to XGE0/0/27 become unavailable.
● The power cable varies according to the delivery country.
Cable Connection
Connect cables according to Figure 2-20 and power on the device. As device does
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for
conguration.
HUAWEI USG6000E Series Quick Start 2 Device Introduction and Cable Connection
Issue 02 (2022-08-22) Copyright © Huawei Technologies Co., Ltd. 23