11
7.2 Powering on VCN540
Turn on the power switch of VCN540, as shown in the following figure.
After the device is powered on, you can check the indicator status on the front panel of the device
to know the device running status and determine whether each system module is running properly.
The following describes the indicators:
1 2
3
Power indicator
Disk status indicator
(eight disks)
No.
1
2
3
Indicator Status Description
GE port LINK indicator
(GE1 and GE2)
Off: The board is not powered on.
Steady on: The system is running properly.
Blinking at a frequency of 0.5 Hz (blinks once every 2s):
The system is being started.
Blinking at a frequency of 1 Hz (blinks once every second):
A component other than the disk is faulty.
Blinking at a frequency of 5 Hz (blinks once every 0.2s):
The disk is faulty.
Off: The network port is improperly connected.
Steady on: The network port is properly connected.
Steady on: The hard disk is properly connected.
Blinking: The hard disk is transmitting data.
Off: The disk cannot be detected, is faulty, not
installed, incorrectly installed, or not powered on.
To Next Page
Loading...
