Qualification Card
1.Safety Precautions
WARNING:
Do not touch the connectors of the power cable or communication cable. Otherwise, you will be
injured by the electric shock caused by the current flow.
Wear an electrostatic discharge (ESD) gloves or wrist strap and antistatic clothing when performing
operations on the device.
Insert filler panels into vacant slots when hard disks are not fully configured.
Connect ground cables to the subrack properly to ensure personnel and device safety.
Replacing a battery incorrectly might result in an explosion. Replace a battery only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
As VDR bridged primary and earth. This built-in type power supply only can be used in permanently
connected equipment, pluggable type B equipment or pluggable type A equipment provided with a
permanently protective earthing terminal.
This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment
may cause radio interference.
CAUTION:
Disconnect the power cord before serving to avoid electric shock.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Double pole/neutral fusing.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
ATTENTION:
Danger d'explosion si la pile n'est pas remplacée correctement. Ne la remplacer que par une pile
de type semblable ou équivalent, recommandée par le fabricant. Jeter les piles usagées
conformément aux instructions du fabricant.
Débranchez le cordon d'alimentation avant de servir afin d'éviter tout risque d'électrocution.
Double pole/fusible sur le neutre.
1
To Next Page
Loading...
