Need help?Do you have a question about the Huawei iMaster NetEco V600R021C10 and is the answer not in the manual?
General| Model | iMaster NetEco V600R021C10 |
|---|---|
| Category | Network Hardware |
| Product Type | Network Management System |
| Version | V600R021C10 |
| Vendor | Huawei |
| Deployment Mode | On-premises |
| Supported Devices | Huawei network devices and third-party devices |
| Management Functions | Performance management |
| Function | Network management |
| Compatibility | Compatible with Huawei network devices |
| Deployment | On-premises, cloud |
Describes the iMaster NetEco hardware installation, cable connection, commissioning, and maintenance.
Lists the target audience for this document, including engineers and technicians.
Defines the meaning of symbols used in the document for hazard identification.
Provides general safety precautions for installing, operating, and maintaining equipment.
Specifies the qualifications and training required for personnel involved in equipment installation and operation.
Covers essential aspects of electrical safety, focusing on grounding and proper connections.
Specifies environmental conditions necessary for equipment installation to prevent fire and faults.
Outlines safety measures for using hoisting equipment and ladders to prevent accidents.
Miscellaneous cautions related to operating specific equipment like cooling products and UPS.
Details the procedure for unpacking and inspecting equipment to ensure all items are intact and comply with the packing list.
Lists common tools and instruments required for installation, noting that specific needs may vary.
States that only trained and qualified personnel can perform installation and operation tasks.
Shows the iMaster NetEco device networking solution in a data center scenario.
Outlines the recommended installation sequence for NetEco devices, from inside to outside the cabinet.
Provides guidance on planning installation layouts for components within a network cabinet.
Details the context, tools, materials, and space required for installing servers.
Describes the procedure for installing a LAN switch, including mounting and connecting cables.
Details the procedure for installing the ECC800-Pro collector into a network cabinet.
Explains the components and appearance of the Smart U Space Manager.
Provides the procedure for securing mounting ears and installing the UIM20A expansion module in a cabinet.
Introduces the installation process for various types of sensors.
Introduces the installation of video management system components like cameras and IVS.
Introduces the installation procedures for access management system components.
Explains scenarios for connecting monitoring cables to servers, detailing port descriptions.
Introduces scenarios for connecting LAN switches, including switch details.
Covers scenarios for connecting ECC800-Pro outside the smart module, including cable preparation.
Provides a checklist for verifying the correct installation of cabinets, including alignment and security.
Lists checks for the correct installation and condition of components within the cabinet.
Details checks for power and ground cable installation, including material and connection integrity.
Outlines checks for signal cable connections, ensuring proper installation and integrity.
Covers essential operations like IP address planning and license acquisition before adding devices.
Covers scenarios for connecting ECC800-Pro within a smart module, including iCooling management.
Introduces scenarios for connecting servers, including SMS modem configuration.
Introduces scenarios for connecting LAN switches and adding devices like iBOX, cameras, and UPS.
Covers scenarios for connecting ECC800-Pro outside the smart module, including IP and RS485 configuration.
Covers routine maintenance tasks, including monthly and semi-annual checks.
Details procedures for replacing components like main control modules, PSUs, and antennas.
Provides steps to troubleshoot abnormal door control status issues in the NetEco system.
Guides on changing the NetEco IP address and updating it on connected devices.
Provides instructions for logging into the NetEco app on a mobile device via WiFi connection.
To Next Page