4.2.3 Connecting the Video Management System Cable
4.2.3.1 Connecting a Monitoring Cable to a Camera
Prerequisites
● A network cable used for monitoring is prepared.
● An idle network port supporting the PoE function is available on the LAN
switch.
● The camera has the PoE function.
Procedure
Step 1 Connect the monitoring port on the camera to any network port on the switch by
using the network cable. The switch is powered by using the power over Ethernet
(PoE) technology.
Device cables not mentioned in the document do not need to be connected onsite
and should be insulated only.
----End
4.2.3.2 Connecting a Monitoring Cable to the IVS1800
Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of the network cable to any GE network port on the IVS1800.
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN
switch.
----End
4.2.4 Connecting the Smart Cooling Product Monitoring Cable
Prerequisites
A network cable used for monitoring is prepared.
Context
When NetCol5000-C(065, 080), NetCol5000-A050/A042/A035/A020/C030/C070/
C150, NetCol8000-A060/A120, or FusionCol8000-E220/E240/E400/C080/C210
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 4 Connecting Monitoring Cables to Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 81
To Next Page
Loading...
Need help?
General
