Huawei iMaster NetEco V600R021C10 - Creating a UPS on the Neteco

6.4.5.5 Creating a UPS on the NetEco
This section describes how to create a UPS on the NetEco.
Prerequisites
● You have the operation rights for Planning Conguration.
● You have created a management domain for the device to be added on the
Planning
Conguration page.
Procedure
Step 1 Log in to the NetEco client.
Step 2 On the main menu, choose Device Management >
Conguration > Planning
Conguration.
Step 3 Choose the management domain where you want to create a device from the
navigation tree on the left.
Step 4 In the lower-left corner of the page, click the Device tab.
Step 5 In the Device area, select UPS from the drop-down list box.
Step 6 Select the device to be added and drag its icon to the management domain.
NO TE
To delete a device, click the device and choose Delete under .
Step 7 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Table 6-15 Modbus-TCP device parameter description
Parameter
Description
Managed Object
Name
Device name
IP Set the IP address of the device.
Port Set this parameter to the port through which the device
connects to the collector.
The port number is 502 by default. You can modify the port
number based on requirements.
Device Address Set this parameter to the address set on the device.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 210