Huawei iMaster NetEco V600R021C10 User Manual

Parameter Description
Connection Mode Connection mode of a device. You can set this parameter to
Non-SSL Connection or SSL Connection.
If you modify the connection mode on the NetEco, you
must modify the connection mode on the device WebUI
accordingly.
NOTE
● The connection mode settings for the NetEco and device must
be the same.
● By default, Connection Mode is set to SSL Connection for the
NetEco and device.
● A non-SSL connection has security risks. You are advised to
select the secure SSL connection.
Authentication
Password
Indicates the re-authentication password for the NetEco
and device.
1. Click Modify. In the displayed dialog box, enter the New
Password and Conrm Password.
NOTE
– After the device is saved, the Modify button is displayed.
– For details about the device password, see the user manual
of the device.
– The device password should be consistent with the NetEco
password.
– If the password does not meet requirements, modify it on
the device.
2. Select a value for Send To Device.
NOTE
If you select YES, the re-authentication password for the NetEco
and device is changed at the same time. If you select NO, only
the re-authentication password of NetEco is changed on the
server.
3. Click OK.
Timeout Period Timeout duration for a connection test. The default value is
3s.
Step 8 Click on the toolbar to save the device information.
Step 9 Click Connection test to start the connection test.
----End
6.4.4.2 Creating Refrigeration Station Devices on the NetEco
This section describes how to add refrigeration station devices (chiller group
control, for example) on the NetEco.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 194

Huawei iMaster NetEco V600R021C10 Specifications

General

Brand	Huawei
Model	iMaster NetEco V600R021C10
Category	Network Hardware
Language	English