Huawei iMaster NetEco V600R021C10 - Creating a PDU on the Neteco

NO TE
The preset user name and password for the PDU8000 are admin and 000001 respectively.
To ensure access security, change the password upon the
rst login.
Step 3 Choose Communication.
1. Set IP address assign to Manual, and set IP address, Subnet mask, and
Gateway.
2. Set SSL to Enable and ModbusTCPcertication to Enable.
----End
6.4.6.3 Creating a PDU on the NetEco
This section describes how to create a PDU on the NetEco.
Prerequisites
● You have the operation rights for Planning
Conguration.
● You have created a management domain for the device to be added on the
Planning
Conguration page.
Procedure
Step 1 Log in to the NetEco client.
Step 2 On the main menu, choose Device Management >
Conguration > Planning
Conguration.
Step 3 Choose the management domain where you want to create a device from the
navigation tree on the left.
Step 4 In the lower-left corner of the page, click the Device tab.
Step 5 In the Device area, select PDU from the drop-down list box.
Step 6 Select the device to be added and drag its icon to the management domain.
NO TE
To delete a device, click the device and choose Delete under .
Step 7 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Table 6-18 Modbus-TCP device parameter description
Parameter
Description
Managed Object
Name
Device name
IP Device IP address
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 215