Parameter Description
Authentication
Password
Re-authentication password for the NetEco and device. The
default value is Modifyme_123.
Step 8 Click on the toolbar to save the device information.
Step 9 Click Connection test to start the connection test.
----End
6.4.9 Adding a CO Power Module
6.4.9.1 Setting Monitoring Parameters for the TP483000D and TP482000B
Before connecting a TP483000D or TP482000B to the NetEco, set the IP address
on the TP483000D or TP482000B.
Prerequisites
● You have obtained the IP address planned for the TP483000D or TP482000B.
● The TP483000D or TP482000B has been powered on and is running properly.
Procedure
Step 1 On the TP483000D or TP482000B LCD, choose Setting Wizard > Comm Para.
Step 2 Set IP Address, Subnet Mask, and Gateway based on the planned data.
----End
6.4.9.2 Creating a Power Module on the NetEco
This section describes how to create a CO power module on the NetEco.
Prerequisites
● You have the operation rights for Planning
Conguration.
● You have created a management domain for the device to be added on the
Planning
Conguration page.
Procedure
Step 1 Log in to the NetEco client.
Step 2 On the main menu, choose Device Management >
Conguration > Planning
Conguration.
Step 3 Choose the management domain where you want to create a device from the
navigation tree on the left.
Step 4 In the lower-left corner of the page, click the Device tab.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 221
To Next Page
Loading...
Need help?
General
