Huawei iMaster NetEco V600R021C10 User Manual

Step 5 In the Device area, select PDU from the drop-down list box.
Step 6 Select the device to be added and drag its icon to the management domain.
NO TE
To delete a device, click the device and choose Delete under .
Step 7 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Table 6-22 SNMPv3 device parameter description
Parameter Description
Managed Object
Name
Device name
IP Set this parameter to the device IP address.
Port Set this parameter to the port number of the device. (set to
161 by default)
Security Name Set this parameter to the user name added in SNMPv3 on
the device.
Authentication
Protocol
Set this parameter to the authentication protocol set on the
device. The default selection is SHA.
Support SHA and MD5 agreement.
NOTE
MD5 is an insecure protocol. SHA is recommended.
Authentication
Password
Set this parameter to the authentication algorithm key
congured on the subdevice.
Value range: a–z, A–Z, 0–9, _ (8–15 characters, at least two
types of characters, dierent from the user name or its
reverse)
Privacy Protocol Set this parameter to the privacy protocol set on the device.
The default selection is AES128.
Support CBC_DES, AES128, AES192, and AES256
agreement.
NOTE
DES is an insecure protocol. AES is recommended.
Privacy Password Set this parameter to the proprietary protocol key
congured on the device.
Value range: a–z, A–Z, 0–9, _ (8–15 characters, at least two
types of characters, dierent from the user name or its
reverse)
NOTE
You are advised to set Authentication Password and Privacy
Password to
dierent values.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 222

Huawei iMaster NetEco V600R021C10 Specifications

General

Brand	Huawei
Model	iMaster NetEco V600R021C10
Category	Network Hardware
Language	English