Figure 6-62 Changing the ECC800-Pro IP address
Step 3 Click Submit.
----End
6.5.1.3 Setting the ECC800-Pro System Type
Prerequisites
● You have obtained the IP address (192.168.8.10 by default) of the ECC800-Pro.
● The browser (Internet Explorer 11 or later, Firefox, or Chrome) for logging in
to the ECC800-Pro WebUI is available.
● You have installed hardware for the ECC800-Pro and powered it on.
● A PC with an IP address in the same network segment as that of the ECC800-
Pro is connected to the ECC800-Pro over a LAN switch.
● You have obtained the IP address, subnet mask, and default gateway planned
for the ECC800-Pro.
Context
When connecting the ECC800-Pro outside the smart module to the NetEco, you
need to set the system type to General.
Procedure
Step 1 Log in to the ECC800-Pro WebUI as an administrator.
Step 2 Choose System > System Parameters > Site
Conguration, set System type to
General, and click Submit.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 230
To Next Page
Loading...
Need help?
General
