Figure 6-2 TaiShan 200 server power button
----End
6.1.5 Logging In to the NetEco Client
This section describes how to log in to the NetEco client using a web browser.
Prerequisites
● The network connection between your PC and the client IP address of the
NetEco is normal and the function of the O&M plane are running properly.
● You have obtained the user name and password for login.
Procedure
Step 1 In the browser address box, enter https://
IP address of the NetEco server
:31943,
and then press Enter.
● 192.168.8.11 is the default IP address of the NetEco.
● Latest Chrome (Stable Channel) and Firefox (ESR Release) are recommended.
● You are advised to set the display resolution as 1920 x 1080 or higher.
● Make sure that the IP address of the NetEco server is not contained in the compatibility view
website.
Step 2 Enter the User Name, Password, and click Login.
● The preset user of NetEco is admin, the preset password is Changeme_123. This user
has all the operation rights on the managed objects. After the
rst login, change the
password in time to ensure account security and prevent unauthorized network attacks,
such as data tampering. Huawei will not be liable for any security issues caused by your
failure to change the preset password in time or password loss after changing.
● If the number of online users reaches the maximum number supported by the system, a
message is displayed, indicating that you cannot log in. In this case, contact the system
administrator.
● After you enter the incorrect password for three consecutive times, you must enter the
verication code upon the fourth login. After you enter the incorrect password for ve
consecutive times, the user account or the IP address is locked for 10 minutes.
----End
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 141
To Next Page
Loading...
Need help?
General
