Figure 6-75 Extended Properties
----End
6.5.2.1.5 Creating the Water Sensor on the NetEco
This section describes how to create Water Sensor icons to bind the managed
objects, indicators, and alarms.
Prerequisites
You have the operation rights for conguring View.
Procedure
Step 1 Log in to the NetEco client.
Step 2 Choose Device Management > Device View > View from the main menu.
Step 3 On the View page, double-click the equipment room where the water sensor is
deployed.
Step 4 Click on the toolbar on the left. The Toolbox dialog box is displayed.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 248
To Next Page
Loading...
Need help?
General
