Step 2 Prepare an RJ45 connector on one end of the network cable by following to the
instruction in 4.3.1 Preparing a Monitoring Cable.
Step 3 Connect the green core wire 6 and the brown-white core wire 7 to the cables
routed out from the door status sensor.
Step 4 Connect one end of the RJ45 network cable to the AI/DI port on the ECC800-Pro
collector.
----End
4.3.6 Connecting Cables to Sensors
4.3.6.1 Connecting Cables to Sensors
If the ECC800-Pro collector is connected to the following types of sensors, connect
cables to the devices by referring to Figure 4-36.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 4 Connecting Monitoring Cables to Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 115
To Next Page
Loading...
