Huawei iMaster NetEco V600R021C10 User Manual

6.4.10.2 Creating an rPDU on the NetEco
This section describes how to create an rPDU on the NetEco.
Prerequisites
● You have the operation rights for Planning Conguration.
● You have created a management domain for the device to be added on the
Planning Conguration page.
Procedure
Step 1 Log in to the NetEco client.
Step 2 On the main menu, choose Device Management > Conguration > Planning
Conguration.
Step 3 Choose the management domain where you want to create a device from the
navigation tree on the left.
Step 4 In the lower-left corner of the page, click the Device tab.
Step 5 In the Device area, select RPDU from the drop-down list box.
Step 6 Select the device to be added and drag its icon to the management domain.
NO TE
● If the management domain is a rack or DDF, click the management domain and choose
Design under . The page for adding a device is displayed.
● To delete a device, click the device and choose Delete under .
Step 7 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Table 6-24 SNMPv1/v2 device parameter description
Parameter
Description
Managed Object
Name
Device name
IP Set this parameter to the device IP address.
Port Set this parameter to the port number of the device. (set to
161 by default)
Read Community Set this parameter to the read community set on the device.
It is recommended that the community be modied every
three months.
Write Community Set this parameter to the write community set on the
device.
Modifying community per three months is advised.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 224

Huawei iMaster NetEco V600R021C10 Specifications

General

Brand	Huawei
Model	iMaster NetEco V600R021C10
Category	Network Hardware
Language	English