Step 3 Set AI/DI_1 to Enable.
Step 4 Click Submit.
Step 5 Select Door sensor from the AI/DI_1 sensor type drop-down list box.
Figure 6-69 Setting a sensor type for a dry contact
Step 6 Click Unhide All Advanced Signals, then click Power Supply Parameters. Ensure
that III power supply enable(AIDI_1/DO) is Yes.
Step 7 Click Submit.
----End
6.5.2.1.2 Setting Smoke Sensor and Water Leakage Sensor Parameters on the
ECC800-Pro Web
After connecting a smoke sensor or water leakage sensor to the AI/DI port of an
ECC800-Pro collector, you need to set smoke sensor or water leakage sensor
parameters on the web user interface (WebUI) of the collector.
Prerequisites
● You have obtained the IP address, and login user name and password for the
ECC800-Pro collector.
● A PC with an IP address in the same network segment as the ECC800-Pro
collector is prepared, and the PC has been connected to the ECC800-Pro
collector over a switch.
Context
● This section describes how to set smoke sensor or water leakage sensor
monitoring parameters when a smoke sensor or water leakage sensor is
connected to the AI/DI_1 port of the ECC800-Pro collector. Set the parameters
based on the actual port connected to the smoke sensor or water leakage
sensor onsite.
● A smoke sensor or water leakage sensor is a
self-identication device. After a
smoke sensor or water leakage sensor is connected to the AI/DI port of an
ECC800-Pro collector, the sensor type is automatically
identied and you do
not need to manually set AI/DI_1 Sensor Type on the WebUI.
To enable automatic device
identication, choose System Settings > Device
Management > Device Addition > Auto Discover Device.
Procedure
Step 1 Log in to the WebUI of the ECC800-Pro collector.
Step 2 Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_1 Port
Settings.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 242
To Next Page
Loading...
Need help?
General
