9
4. How do I restore the router to its factory settings?
Connect the router to the power supply and wait until the
router completes the startup process. Use a needle or pin
to press the RESET button on the router for more than two
seconds until the indicator light goes out. Wait for the router
to complete the restart process. When the indicator turns red,
this indicates that the router has been restored to its factory
settings.
If the problem persists, restore the router to its factory settings
and follow the instructions in this guide to reconnect the cables
to the factory settings so that it/they can automatically connect
Ethernet cables are well connected and in good condition.
your broadband account and password. If the problem
persists, contact your carrier for assistance.
5. How do I connect an add-on HUAWEI router to my
HUAWEI WiFi Mesh 3 to expand the Wi-Fi network?
You can connect the router in either of the following ways:
router (new or restored to factory settings) to the LAN port
cable.
Step 1: Place the add-on router (new or restored to factory
Mesh 3 and connect it to the power supply.
Step 2: When the indicator on the HUAWEI WiFi Mesh
To Next Page
Loading...
Need help?
General
