212 Series Tooling Alcoa Fastening Systems
5
The Model 212 is a lightweight, high speed pro-
duction tool designed to install a wide range of
Huck blind fasteners, and HUCKBOLT®
Fasteners, including 3/16" and 1/4" diameter
MAGNA-GRIP® Fasteners and MAGNA-LOK®
Fasteners.
Pulling action of the pull piston is provided by a
pneumatic-hydraulic (pneudraulic) intensifier
system powered by 90-100 psi air pressure. The
air inlet is equipped with a connector with 1/4-18
female pipe threads to accept your air hose or
quick connect fitting. The piston return stroke is
spring actuated.
A nose assembly is required for each fastener
type and size. Nose assemblies must be
ordered separately.
Weight 8.50 pounds (3.0 kg.)
Length of Head (1) 9.00 inches (228 mm)
Width of Head (1) 1.44 inches (37 mm)
Edge to Centerline 72 inches (18 mm)
Cylinder Diameter 4.63 inches (118 mm)
Height13.00 inches (330 mm)
Air Pressure 90-100 psi (620-690 kPa)
Air Consumption* 6 CFM (0.003 m 3/s)
Minimum Stroke .812 (20.6 mm)
Minimum Pull Force @90 psi 5,200 psi (35,535 kPa)
* (based on 30 fastener installations per minute.)
(1) Weight and length of tool does not include nose assembly.
Fasteners installed: See SELECTION CHARTS or your Huck representative.
Hydraulic Fluid: Automatic Transmission fluid, *DEXRON II, III or equivalent.
DEXRON II & III are registered trademarks of General Motors Corporation.
DESCRIPTION
SPECIFICATIONS
To Next Page
Loading...
