Need help?Do you have a question about the Huck Arconic 507 and is the answer not in the manual?
Details Huck International, LLC as manufacturer and Rob Pattenden as European representative.
Lists Model 507 family hydraulic installation tools.
Declaration of conformity signed by Robert B. Wilcox.
Declared noise and vibration emission values according to ISO and EN standards.
Explains CE marking, manual reading, eye/hearing protection, and warning symbols.
Covers training, maintenance, tool usage, guarding, and specific handling precautions.
Covers Projectile, Operating, Repetitive Motion, Accessories, Workplace, Noise, and Vibration hazards.
Specific safety rules for hydraulic tools, including pressure and fluid handling.
Describes the tool's design and compatibility with HUCKBOLT® and HUCKLOK® fasteners.
Importance of correct pressures and availability of checking gauges.
Details power source, hoses, temp, flow, pressure, capacity, stroke, weight, and fluid.
Strong warning about using only Huck Powerig units and avoiding those without relief valves.
Details trigger control, pull stroke, clamping, pintail break-off, and return stroke.
Emphasizes reading all warnings and cautions before operating.
Step-by-step guide for connecting hoses and trigger cord to the Powerig unit.
Technical note on serial number specific differences for nose assembly parts.
Critical warnings: eye/ear protection, clearance, specific handling, no bending, correct usage.
Step-by-step guide for installing a HUCKBOLT fastener, from preparation to cycle completion.
Lists service kits, hex keys, wrenches, and clamp kits with their uses and part numbers.
Identifies O-ring/back-up rings and instructions for preparing coupling surfaces.
Cautions, importance of preventive maintenance, and system inspection steps.
Specific maintenance for POWERIG, Tool, and Nose Assembly, including seal replacement.
Recommendation to update older tools with current configurations.
Information on the availability and benefit of a Suspension Bracket.
General precautions for disassembly/assembly: clean surface, soft materials, continuous pressure, alignment, lubrication.
Information on special tools, standard hand tools, and lubricants required.
Safety notes regarding Powerig and electrical disconnection before disassembly.
Detailed steps for disassembling the tool, from rings to O-rings.
Pre-assembly checks: cleaning, inspection, replacing seals; warning about omitting seals.
Step-by-step guide for assembling the tool's cylinder, piston, cap, and hoses.
Instructions for assembling the handle, cord grip, and switch.
Warning that the tool must be fully assembled with all components.
General advice: check simple causes first, proceed logically, use known parts.
Addresses issues like tool failure, leaks, overheating, erratic operation, and fastener problems.
Details lifetime, 2-year, and 90-day warranties for different tool components.
Defines 'useful lifetime' and disclaims warranties for third-party items.
Information on Huck installation equipment service and contact points for repair facilities.
Company profile and mission statement about creating breakthrough products.
Contact and address information for Americas, Europe, and Far East offices.
Notices regarding service marks, guidance, and warranty disclaimers.
To Next Page
General
