Need help?Do you have a question about the Hughes & Kettner Blonde Edition and is the answer not in the manual?
General| Brand | Hughes & Kettner |
|---|---|
| Model | Blonde Edition |
| Category | Amplifier |
| Language | English |
Describes the CLEAN channel's tone, volume, and potential for crunch.
Covers the LEAD channel's sound and the function of the MID control.
Explains the reverb's placement and automatic level adjustment.
Details the INPUT, CLEAN VOL, CHANNEL SELECT, and RED LEAD LED on the front panel.
Describes the MAINS connection and the importance of matching local voltage.
Information on basic connections and setup for the amplifier.
How to switch between CLEAN and LEAD channels using the switch or footswitch.
Guidance on using the effects loop with external signal processors.
Recommendations for routing the amp's signal to a mixing console via a RED BOX.
Checks for power issues, mains cable connection, and fuse problems.
Troubleshooting steps for no sound, including controls and shorts.
Diagnosing issues with the footswitch not changing channels correctly.
Addresses interference and ground loop issues with LINE OUT/LINE IN connections.
Troubleshooting distorted audio when using an FX processor with the LINE OUT.
Resolving issues with low signal volume when using an FX processor.
Details on preamp circuit, input/output levels, and frequency response.
Information on voltage, power consumption, fuses, dimensions, and weight.
To Next Page