Need help?Do you have a question about the Hughes & Kettner Tour Reverb and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Channels | 2 |
| Effects Loop | Yes |
| Speaker | 1 x 12" |
| Reverb | Spring Reverb |
| Weight | Approx. 20 kg (44 lbs) |
| EQ | 3-band EQ |
| Footswitch | Channel Switching |
| Dimensions | 480 x 250 x 240 mm |
Details impedance and level specifications for INPUT, FX RETURN, FX SEND, and LINE OUT.
Outlines power output, frequency response, loudspeaker, and headphone specifications.
Specifies the power output for the headphone jack.
Covers mains voltage, power consumption, fuses, dimensions, and weight.
Describes full-bodied clean sounds with headroom and a specially tweaked Clean channel.
Covers an impressive tonal spectrum from clean to gritty overdrive, sensitive to picking attack.
Delivers vintage and contemporary rock sounds with immediate, dynamic response and Voicing knob.
Features ACCUTRONICS® 3-spring reverb for warm sound, placed after the FX loop.
Details INPUT, CLEAN VOL, EQ SECTION, Channel Select button, and associated LEDs.
Describes MAINS SOCKET, HEADPHONES, SPEAKER OUT, LINE OUT, FX SEND, FX RETURN, and Footswitch jacks.
Provides guidance on basic setup and connecting cables for operation.
Explains how to activate the three channels using buttons or a footswitch.
Details the parallel FX loop, connecting effects, and proper signal mixing.
Describes the LINE OUT circuit for routing the amp's signal to consoles or other equipment.
To Next Page