16
Getting Started
Reset the Triplog
T
he Triplog includes the timer for elapsed time, distance traveled since last reset, and average speed. Use the following instructions
to reset the triplog. To display the Triplog as a digital readout, see Views: Display Digital Readouts.
1. Main Menu: Press the MENU key twice.
2. Select the Setup tab.
3. Select Triplog Reset.
4. Press the RIGHT Cursor key.
5. Follow the on-screen prompts.
Turn on/off Sound
Use the instructions in this section to choose the category of sounds you want to hear from your control head.
1. Main Menu: Press the MENU key twice.
2. Select the Setup tab.
3. Select Sound Control.
4. Select All Sounds or Alarms only.
To receive a sound alert from an alarm, Sound Control must be set to All Sounds or Alarms Only.
Change the Alarm Tone: Select the Alarms tab > Alarm Tone.
Change the User Mode
The User Mode determines how many menu options are displayed in the menu system. Select Normal to see fewer menu options
that are used more often. Select Advanced to see all the menu options available in the menu system.
Instructions in this manual marked with Main Menu (Advanced User Mode) indicate that the menu system User Mode must be set
to Advanced for the selected menu to be shown. If you do not see the menu in the system, change the User Mode to Advanced. See
Menu System Overview for details.
1. Main Menu: Press the MENU key twice.
2. Select the Setup tab.
3. Select User Mode.
4. Select Normal or Advanced.
Set up Sonar
If you’ve installed an accessory transducer, or to refine your sonar settings, see Set up Sonar for details.
Set up Chart Preferences
If you’ve installed a microSD map card, see Chart Overview to set up the map source.
To Next Page
Loading...
Need help?
General
