Hunter 23298 - 3. Assembling and Hanging the Fan

6
41874-01 • 08/13/09 • Hunter Fan Company
3-1. Install three 25 Watt Candelabra bulbs.
3-2. Place the glass uplight onto the fan assembly.
3-3. Insert the downrod through the canopy, canopy trim ring, and
glass uplight. Feed the wires from the fan through the downrod.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-4. Loosen the set screw. Screw the downrod into the fan assembly.
Retighten the set screw.
3-5. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim of the canopy.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3 • Assembling and Hanging the Fan
Downrod
Canopy
Canopy
Trim Ring
Set Screw
Step 3-2
Glass Uplight
Fan
Assembly
Step 3-3
Step 3-5
U-shaped
Hole