Why doesn't the program change at my desired setting on my Hunter Thermostat?
If your program isn't changing at the desired setting, check the following: * Ensure the time is correctly set to “AM” or “PM”. * Make sure the thermostat is not in "HOLD" mode. * Verify the correct day setting.
How to fix no display on Hunter 44300?
If there is no display on your Hunter Thermostat, try the following: * Check the battery connections and the batteries themselves. * Press the reset button once with a small pin and hold it in for two seconds.
What to do if heating or cooling does not turn on or off on my Hunter 44300 Thermostat?
If your heating or cooling system isn't turning on or off, consider these steps: * Ensure the function switch is in the correct position, either “HEAT” or “COOL”. * Allow up to 20 seconds for the system to respond. * Check circuit breakers and switches to confirm power to the system. * Replace the batteries. * Ensure the furnace blower door is properly closed. * For 4-wire systems, verify the jumper wire is installed between the RC and RH terminals.
What to do if auto/fan does not come on in Hunter Thermostat?
If the AUTO/FAN function isn't working, try moving the HG/HE system selector to the opposite position.
Why is the entire display dim on my Hunter Thermostat?
If the entire display dims, try replacing the batteries.
How to resolve a scrambled or double display on Hunter 44300 Thermostat?
To resolve a scrambled or double display, remove the clear mylar sticker.
What to do if my Hunter 44300 reads HI, LO permanently?
Replace unit.
What to do if Hunter 44300 Thermostat continues to operate in the OFF position?
Replace unit.
What causes an erratic display on a Hunter Thermostat?
If you are experiencing an erratic display, press the reset button once with a small pin and hold it in for two seconds, then reprogram the thermostat.
General| Brand | Hunter |
|---|---|
| Model | 44300 |
| Category | Thermostat |
| Language | English |
Instructions for safely removing the existing thermostat from the wall.
Guide to labeling wires from the existing thermostat before disconnection.
Configuration of system selectors and final wire connections for the thermostat cover.
How to set the current time and day on the thermostat for accurate scheduling.
Temporarily change temperature without altering the programmed schedule.
Addresses problems like scrambled display, no display, and program errors.
To Next Page
