PAGE 16
16-17
PROGRAMMING
Remove the mylar label covering the LCD display window before operating thermostat.
Setting Time and Day
HOUR
MIN
DAY
RETURN
EXAMPLE:
Set the
thermostat
to the
current time
of 9:43 a.m.
on
Saturday.
Refer to
Figure at
right.
■ During time and day setting mode, the temperature and program
displays will go blank.
■ Press and hold to rapid advance to the current hour. Tap to advance one
hour at a time. Note the AM / PM indicator, as the display will cycle
through 24 hours.
■ Press and hold to rapid advance to the current minute. Tap to advance
one minute at a time.
■ Tap to advance one day at a time.
■ When finished, press to return to the Normal time and temperature
display or wait 15 seconds for it to return to Normal mode automatically.
■ Initial display after power-up or reset. The LCD will show the information
when batteries are first installed, or after the Reset button is pressed. The
temperature will update after a few seconds.
M T W Th F Sa Su
AUTO COOL HEAT TEMP
12
:
00
SET TEMP
°
C
H
°
C
H
AM
PM
72
MTWThFSa Su
AUTO COOL HEAT TEMP
8 9
:
43
SET TEMP
°
C
H
°
C
H
AM
PM
88
MTWThFSa Su
AUTO COOL HEAT TEMP
8 9
:
43
SET TEMP
°
C
H
°
C
H
AM
PM
71
To Next Page
Loading...
Need help?
General
