Gather all tools necessary to complete your installation
before removing the old thermostat.
To install your thermostat you should have the
following tools:
Slotted Screwdriver
Phillips Screw Driver
Electric Drill and 3/16” drill bit
Hammer
Four 1.5v (AA) size alkaline batteries
Unpack your new Hunter
®
thermostat and ensure all
components are present in the Accessory Pack. This
includes:
2 - #8 slotted screws
2 - wall anchors for mounting
1 - sheet of terminal labels
1 - jumper wire
1 - thermostat with mounting plate.
Before you Begin
44668 ThermosTaT
This guide will make installation and programming
your new thermostat simple and fast. In just a few
minutes, you can have the Comfort Saver with Room
Control installed, programmed and ready to go. Videos
showing each step of installation and programming
are available at www.hunterfan.com/comfortsaver. Of
course, if you have additional questions, please call
our help line at 1-888-830-1326 from 7:00 am to 7:00
pm Monday – Friday or 8:00 am to 5:00 pm (Central)
on Saturday. You may also contact us online at www.
hunterfan.com.
©2009 Hunter Fan Company 43078-01 • 12/18/08
To Next Page
Need help?
General
