Hunter 44905 - Setup; Setting Day, Time, and System

44040-01 • 03/24/2010
8
4
Setup
Setting Day, Time, and System
Once you install the batteries, the thermostat will prompt you to set the current date,
time, and system type.
1. “01” for current day will be ashing. Use the or button to select your current day,
then
Next
to move to month, and then year, until each is set.
Next
will advance you to time
setup.
2. Use the the
or buttons to set the current time of day, AM or PM and then use
Next
to
advance to hours, and again to set minutes. Pressing
Next
again will advance you to system
setup.
3. Press [conventl] or [heat pump] to select your system type. You may also use the
or
buttons to make your selection.
Note: At anytime, if you see the
?
icon on the screen, you can press it for more
information about that setup, scheduling step, or menu option.
4. If you selected [conventl], select [gas/oil] or [electric] as your furnace type.
Note: Furnace type should be [electric] for heat pump systems.
5. Press
Next
. Choose [Schedule] if you want to setup your schedules or [manual] to set
one temperature and ignore scheduling. Press
Next
and See “Setting Your Schedule”
on page 12 if you chose [Schedule] or use the or buttons to set your temperature
and press
Done
for [manual] mode.