Hunter 59629 - Assembling the Light Kit

8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Control
Installing the Canopy
Installing the Blades:
Installing the Bulbs and Glass
ON
Turn Power
Lift the globe and align the notches
in the globe with the tabs in the
light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Assembling the LIght Kit
Notch
Tab
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Fan style may vary.
Note:
Partially install two light kit screws, found in the
hardware bag, halfway into the motor housing as shown.
It does not matter which two screw holes you choose.
1
STEP
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise. Install the
third light kit screw. Tighten all screws securely.
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Turn the light kit counterclockwise until the
light kit screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
2
STEP
3
STEP
4
STEP
5
STEP
2 of 6
Light Kit Screw
2 of 6
Light Kit Screw
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
bag
bag
bag
bag