Hunter 80707 - Existing Construction: Accessible From Above (Continued); Motor Reinstallation and Securing; Power On and Testing

43053-01 - 09/12/2011
13
C25
C26
C23
C24
Connect wiring from motor the motor
to the wiring cover plate.
Secure the motor by tightening the 2 screws.
Tighten the strain relief screws.
Reinstall the motor by inserting the tabs and pushing up into
position. Make sure the wires are not pinched between the motor
and the housing.
Install the wiring cover plate. Make sure all wiring connections
are inside the box or under the wiring cover plate.
Go to step F1 on page 20 to connect the wires as shown.
F1
C22
C21